Search
Now showing items 1-10 of 23
The Influence of Cooling Rate on the Microstructure and Microsegregation in Al–30Sn Binary Alloy
lubricant. Despite extensive research on solidification behavior of Al–Sn and Al–Sn-based alloys, microsegregation is not yet fully understood. The aim of this article is to study the effect of cooling rate on the microsegregation of Al–30 wt% Sn. Three...
Effect of cooling rates from partial solution temperature and aging on خ³â€² precipitation in IN792 superalloy
Investigations of optimization of the cooling rate during after-product cooling crystallization
When carrying out measurements of cooling crystallization in crystallizers in different sugar factories it was found, that supersaturation diminishes at cooling rate of 1 ti 2 K/h in initial phase. It is only at low temperatures that supersaturation...
Flash cooling crystallization with after-product magma
Today, most sugar factories operate with approximately linear cooling curves. The cooling rate is about 1 K/h. Such a slow cooling rate leads to crystallization periods lasting more than 40 h. Because of the dependence of the crystallization rate...
Steady and dynamic shear rheological behavior of semi dilute Alyssum homolocarpum seed gum solutions: influence of concentration, temperature and heating–cooling rate
BACKGROUND
Alyssum homolocarpum seed gum (AHSG) solution exhibits high viscosity at low shear rates and has anionic features. However there is no information regarding the flow and dynamic properties of this gum in ...