Search
CSV
RISContinuous time common mode feedback technique for sub 1 V analogue circuits
A continuous time common mode feedback technique for sub 1 V analogue circuits using the bulk PMOS dynamic threshold (BP-DTMOS) technique is presented. The proposed method is used
in a 0.8 V folded cascode amplifier ...
A Fully Digital Front-End Architecture for ECG Acquisition System With 0.5 V Supply
This paper presents a new power-efficient
electrocardiogram acquisition system that uses a fully digital
architecture to reduce the power consumption and chip area.
The proposed architecture is compatible ...
Design of a memristor based fuzzy processor
This paper presents a mixed-signal hybrid CMOS/Nano circuit to implement a fully programmable fuzzy processor that performs the zero-order Sugeno's algorithm. The programmability is incorporated in both the rule base and ...
Enhancing Power Supply Rejection of Low-Voltage Low-Dropout Voltage Regulators Using Bulk Driven PMOS
In this paper a low-voltage low-dropout (LDO) regulator is presented in which the power supply rejection (PSR) is increased by properly driving the bulk of the PMOS pass transistor. A signal proportional to the supply noise ...
A Low-Power Area-Efficient Dynamic Circuit Using Conditionally Charging Pattern with Embedded Latching Capability
Abstract— High speed and small area are the main advantages
of the dynamic logic for digital circuits. Power consumption of
this logic family is the main drawback. In this paper a new
method for reducing ...
A New Power Efficient Wireless Non-Uniform Adaptive-Sampling ECG Recording System
Abstract—This paper presents a new successive approximation analog to digital converter (SA-ADC) with wireless transmission which samples sparse signals in a non-uniform adaptive way and transmits the samples power-efficiently. ...
A Programmable Ultra Low Power Analog Band-Pass Filter for Cochlear Implants
Inthis article an ultra low power analog programmable band-pass filter for cochlear implants (CIs) is designed. In order to decreasethe power consumption, a subthresholdGm-Cstructure is used and also capacitiveattenuationtechnique ...
Using DTMOS technique in the design of common mode feedback in a 0.8 V folded cascode amplifier
A continuous time common mode feedback (CMFB) technique for sub 1-V analog circuits using the bulk PMOS dynamic threshold @P-DTMOS) technique is presented. The proposed method is used in a 0.8V folded cascode amplitier. ...
A 0.8V ΔΣ modulator using DTMOS technique
A 0.8V second order ∆Σ modulator is designed in 0.18µm bulk CMOS technology. Dynamic threshold MOSFET (DTMOS) technique is used to enhance the performance of the circuit building blocks at very low supply voltage. Schematic ...
A novel auto-zero technique for a bio-implantable blood pressure monitoring device
A bio-implantable integrated circuit is discussed in this paper. The implemented circuit is designed for monitoring blood pressure of transgenic mice. Due to small available volume, the power consumption is the primary ...