Search
Now showing items 1-10 of 24
Thermo-rheology and thermodynamic analysis of binary biopolymer blend: A case study on sage seed gum-xanthan gum blends
of SSG and XG chains increased and decreased, respectively, while the molar mass distribution of all gum chains increased. The yield stress at both long and short timeframes increased with temperature for SSG and 3-1 SSG-XG, although other dispersions...
Mechanisms of quasi preconsolidation stress development in clays: A rheological model
Rheological Behavior of Zinc-Oxide Nanolubricants
fraction. Thereby, rheological data revealed that nanoparticles make aggregates in the turbine oil with diameter about 3.6 of diameter of a single nanoparticle. Moreover, temperature effect on viscosity and yield stress of nanolubricants is shown...
Influence of variety, concentration and temperature on the steady shear flow behavior and thixotropy of canary seed (Phalaris canariensis) starch gels
In this study, the rheological properties of starch gels from two varieties of canary seeds (CDC Maria and CO5041) were investigated. The experimental conditions were different concentrations (4%, 6% and 8% w/w at constant ...
Modeling Time-Independent Rheological Behavior of Pistachio Butter
temperatures. It was found that pistachio
butter behaved as a non-Newtonian pseudo-plastic fluid with yield stress value. Seven
models were used to describe time-independent flow behavior of all samples. To evaluate
the ability...
Dynamic viscoelastic study on the gelation of basil seed gum
.5% strain. Storage modulus (G′) was greater than loss modulus (G″) in all concentrations and they increased by improving BSG concentration. Yield stress value was determined by stress sweep and it increased from 1.40 to 7.47 Pa when BSG concentration...
DIRECT AND INDIRECT METHODS TO EVALUATE THE YIELD STRESS OF SELECTED FOOD HYDROCOLLOIDS
Nowadays, the rheological and industrial importance of hydrocolloids is completely obvious. For many years, yield stress has been discussed as one of the most important parameters in the rheological behavior of hydrocolloids. Among the direct...
An advanced criterion based on non-AFR for anisotropic sheet metals
is called here „advanced criterion‟. Totally eighteen experimental data are required to calibrate the criterion contained of directional tensile and compressive yield stresses for the yield function and directional Lankford coefficients for the plastic...
Phase concept for mudflow based on the influence of viscosity
Non-linear influence of hydrostatic pressure on the yielding of asymmetric anisotropic sheet metals
dependent on hydrostatic pressure, while the plastic potential functions are introduced to be pressure insensitive. To calibrate these criteria, the yield functions need 10 directional experimental yield stresses and the plastic potential functions need...



CSV
RIS