Search
CSV
RISEvolution of residual stress distribution and microstructure in a platinum aluminide coating
An experimental investigation of casing effect on mechanical properties of billet in ECAP process
of billet, strain homogeneity, compression strength of billets, and stress distribution in the deformation zone are investigated....
FEM-based simulation of the mechanical behavior of grapefruit under compressive loading
Bruising in fresh crops is a major challenge of the horticulture industry, which can cause quality degradation and losses throughout the pre-harvest to the post-harvest stages. A visual understanding and/or detailed ...
Design Optimization of an Orthopedic Screw Based on Stress Stimulus Using Taguchi Method and Finite Element Analysis
significant influence on stress shielding. Greater STP values means stress distribution is more uniform in the vicinity of bone-implant interface, which results in less stress shielding....
A new analytical method for stress analysis of finite plates with circular cutout
This paper investigates the stress distribution around a circular hole in a finite isotropic plate. The main problem in this analysis is how to apply the boundary conditions at the cutout boundary, which is represented in the Polar coordinate...
Analytical solutions for adhesively bonded composite single-lap joints under mechanical loadings using full layerwise theory
solved by introducing the state space variables. The effects of adhesive thickness and loading conditions including uniaxial tension and bending moment on the interfacial peel and shear stress as well as the von Mises stress distributions along the length...
Factors affecting stress distribution of a 3أ—3 pile group in dry sand based on three dimensional large shaking table tests
Accurate Water Hammer Pressure Modeling for Trial Modification of Stress Distribution Along Multi Segments Pipeline
of pipe thickness and stress distribution....
An analytical solution for buckling of plates with circular cutout subjected to non-uniform in-plane loading
This paper investigates the buckling of isotropic plateswith circular cutout subjected to non-uniform
in-plane loading. The buckling load is calculated in two steps. In the first step, the prebuckling stress distribution
is computed...