Search
CSV
RISStudy on hot deformation behaviour of 316LN austenitic stainless steel based on hot processing map
Phase reversion induced nanograined austenitic stainless steels: Microstructure, reversion and deformation mechanisms
Analysis of internal cracks in Type 304 austenitic stainless steel cladding wall of regenerator column in amine treating unit
The present study aims at investigating the incidence of internal cracks in Type 304 austenitic stainless steel cladding wall of Methyldiethanolamine (MDEA) regenerator column in amine treating unit. The toxicity of hydrogen sulfide (H2S) makes...
On the material characteristics of a high carbon cast austenitic stainless steel after solution annealing followed by quenching in a CNT nanofluid
Solution annealing followed by quenching in carbon nanotubes
(QCNT) nanofluid treatment was applied to generate
very high interstitial carbon content,&0.30 wt.%, in an austenitic
stainless steel (ASS). ...
Magnetic investigation of strain induced martensite evolution
In this work the magnetic properties of AISI 304L austenitic stainless steel was subjected by using the
magnetic induction with different working frequencies. For this purpose a sheet rolled from 10 to 80
% reduction at 0ᵒC was used...
Influence of strain rate on hot ductility of austenitic stainless steel slab
Investigation on hot deformation of 20Cr 25Ni superaustenitic stainless steel with starting columnar dendritic microstructure based on kinetic analysis and processing map
Using Gray Relational Analysis and Taguchi Technique in Solving Multi-objective Problems for Turning Operation of Austenitic Stainless Steel
single objective used to determine the best set of process parameters for turning operation of AISI 202 austenitic stainless steel. Analytical results reveal that the combination of higher levels of cutting speed, depth of cut, and nose radius and lower...
Examination of Barkhausen noise parameters for characterisation of strain-induced martensitic transformation in AISI 304 stainless steel
In this study, the strain-induced martensitic transformation in AISI 304 stainless steel after tensile deformation was investigated using different magnetic Barkhausen noise (MBN) parameters. For this purpose, different ...
Correlation between the surface coverage of severe shot peening and surface microstructural evolutions in AISI 321: A TEM, FE-SEM and GI-XRD study
Severe shot peening (SSP) as a surface severe plastic deformation (S2PD) process over a wide range of coverages was applied to generate gradient microstructures with the grain size increasing from nanometer- and micron-scale ...